CNC milling machines
CNC Lasers
Categories
Goods are just viewed by 8 people
Two flute carbide Ball nose end mill R3mm 75mm AlTiN
Specifications:
Shank diameter 6 mm
Cutting diameter 6 mm
Cutting length 12 mm
Overall length 75 mm
2 Flutes solid carbide mill cutter slot drill
Two flutes for standard cutting and high rate of chip removal
With AlTiN coated for increasing cutting stability, edge retention and up to three times longer cutting life
Spiral design, greatly improve the cutting speed, makes a smooth and delicate cutting surface
High precision super sharp, wear-resistant, durable
Used for semi-finishing operations, do slotting, profiling & plunging operations
Suitable for: Steel, Cast Iron and General Use on Materials up to 45HRC,
Cast Iron, Nodular Cast Iron - RPM 8000 Feed 1050 mm/min
Carbon Steel, Alloy Steel -750N/Mm2 - RPM 8000 Feed 1050 mm/min
Carbon Steel, Alloy Steel 30HRC - RPM 6400 Feed 800 mm/min
Pre Hardened Quenched and Tempered Steel 40HRC - RPM 5300 Feed 580 mm/min
173-DKGFA06/124530060075
1 Item
Data sheet
- Cutting edge diameter
- 6 mm
- Shank diameter
- 6 mm
- Cutting edge length
- 12 mm
- Total length
- 75 mm
- Hardness
- HRC 45
- Protective coating
- AlTiN
- Number of flutes
- 2
- Type of end mill
- Ball nose end mill
- Tool material
- Solid carbide
Comments (0)
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.
Your review cannot be sent
Specifications:
Shank diameter 6 mm
Cutting diameter 6 mm
Cutting length 12 mm
Overall length 75 mm